Field          Engineering Technology

 

Review of Engineering Core Skills unit standards

 

Subfield

Domain

ID

Mechanical Engineering

Engineering Core Skills

2395, 2396, 21911, 21912

 

Competenz has completed the review of the unit standards listed above.

 

Date new versions published                                                          September 2016

 

Planned review date                                                                           December 2021

 

Summary

 

As a result of the Targeted Review of Qualifications process, Competenz has reviewed safety unit standards for inclusion in New Zealand Certificates in Mechanical Engineering and Fabrication.  This process led to the review of four existing, and development of three new unit standards to reflect conditions listed in the graduate profile outcomes requiring knowledge and application of safety in mechanical engineering and fabrication.

 

Meetings with subject matter experts were conducted, identifying the required content and comparing this content against existing unit standards.  It was identified that the current unit standards were not suitable for the specialist requirements for safety in mechanical engineering and fabrication environments.  The review of existing and content of new standards is based on extensive feedback with industry experts and is endorsed by industry and providers.

 

Main changes

 

·      Development of one new unit standard for health and safety when welding and thermal cutting.

·      Development of one new unit standard for health and safety when using powered machinery and equipment.

·      Development of one new unit standard for hazard and risk identification and management within a mechanical engineering or fabrication environment.  While there are existing unit standards for risk and hazard identification (17602, 25046) it was felt by industry that these are too generic to meet their needs after the introduction of the Health and Safety at Work Act (2015), so a more contextualised unit standard has been developed.

·      Addition of more detailed knowledge in the selection and safe use of hand and power tools has been incorporated into unit standards 2395 and 2396.

·      Greater focus on the effects that hazards can have on long-term health and immediate safety has been incorporated into unit standards 21911 and 21912.

 

The last date for assessment of the most recent superseded versions of Category B unit standards is December 2021

 

Detailed list of unit standards – classification, title, level, and credits

 

All changes are in bold.

 

Key to review category

A

Dates changed, but no other changes are made - the new version of the standard carries the same ID and a new version number

B

Changes made, but the overall outcome remains the same - the new version of the standard carries the same ID and a new version number

C

Major changes that necessitate the registration of a replacement standard with a new ID

D

Standard will expire and not be replaced

 

Engineering and Technology > Mechanical Engineering > Engineering Core Skills

ID

Title

Level

Credit

Review Category

2395

Select, use, and care for, engineering hand tools

Demonstrate and apply knowledge of the selection, use, and care of engineering hand tools

2

4

B

2396

Select, use and maintain portable hand held engineering power tools

Demonstrate and apply knowledge of the selection, use, and care of portable hand held engineering power tools

2

4

B

21911

Demonstrate knowledge of safety on engineering worksites

2

2

B

21912

Apply safe working practices on an engineering worksite

2

2

B

29650

Demonstrate knowledge of the safe use of powered equipment in a mechanical engineering or fabrication workshop

2

2

New

29651

Demonstrate knowledge of health and safety when welding and thermal cutting

2

3

New

29652

Demonstrate knowledge of safety, health, risk assessment, and hazard ID and control on an engineering worksite

3

3

New